SAMSUNG WASHING MACHINE CODES CODE

Remove the front panel from your washer so you can access the drain pump.Open the door and disconnect the drain hose from the machine. Next, locate the small door on the side of the washing machine.Remove the top panel of your front-loader washer by unscrewing the screws that hold it in place and then pulling it off.The easiest way to check if the pump is faulty is to use a multimeter to check the pump for continuity.

The drain pump is responsible for helping water drain from your Samsung washer at the end of a wash cycle. If the drain hose or the filter weren’t the cause of the error code, the next component to check is the drain pump. If it’s still showing, proceed to the next step.

SAMSUNG WASHING MACHINE CODES CODE

Plug your Samsung washer back in and turn it on to check if the ND error code has stopped showing.

Place the filter back into the washer, put the plug back in, and reconnect the drain hose.

Clean the filter with soapy water and then let it dry.

To remove the filter, disconnect the drain hose from the washer and remove the plug.,Then remove the filter by turning it and pulling it out.

Open the washer door and locate the drain filter on the bottom of your washer.

The easiest way to check the drain filter is to: When it gets blocked with debris, your washer won’t be able to drain, which can cause the ND error code to show on your display screen. The drain filter is part of the drain pump component in your Samsung washer. The next possible drainage problem to investigate is if the drain filter is blocked. Turn your washer on and then check if the ND error code has stopped showing.

Once you’ve gone through the above steps, reattach the hose to your Samsung washer and the wall.

If it’s clogged, you can use a piece of wire to unblock it.

If the drain hose isn’t damaged, remove the hose from both the wall and your Samsung washer and then make sure it isn’t blocked.

If the hose is heavily damaged, it will need to be replaced.

Find the drain hose and make sure there are no kinks, crimps, or holes in it.

Slowly pull your Samsung washer out from the wall so you can gain access to the back of it.

The quickest way to check the drain hose is to: If the hose gets blocked with loose debris, your washer won’t be able to drain and the ND error code will show up on your display screen. When your Samsung washer drains, the water empties through a drain hose. WF448AAPXAA Make sure the drain hose isn’t blocked This guide covers all major Samsung front-load washer models, including: To find out which component is causing the ND error code, simply start from the top of this guide and work your way down until you fix your Samsung front-loading washer. However, sometimes the ND error code is caused by a faulty drain pump, which is harder to repair or replace. Usually, a drainage component, such as the drainpipe or drain filter, is blocked and will need to be cleaned out or adjusted.

The ND error code means your Samsung front-load washer’s drainage system has a problem.

Samsung washing machine codes